Custom fit kit for mounting a Thule roof rack to vehicles without pre-existing roof rack attachment points, or factory-installed racks.
Check the Thule Buyer's Guide to find out which fit kit fits your car:
https://www.thule.com/en-gb/buyers-guide?c=roof+racks&q=UuHU2xa4E
Fit kit for vehicles without pre-existing roof rack attachment points or factory-installed racks
Compatible with Thule Evo Clamp and Thule Edge Clamp foot packs
Classic steel square bars with black polymer coating. 2-pack.
108 cm (43 in)
200 cm
Standard steel load bar available in a variety of lengths
Check the Thule Buyer's Guide to find out which roof rack fits your car:
https://www.thule.com/en-gb/buyers-guide?c=roof+racks&q=UuHU2xa4E
Plastic coating provides additional grip for rooftop cargo
Load bar for Thule Evo roof rack system
Colour
Black
Model number
712200
Loading width
118
An around-the-bar adapter for fitting your Thule bike rack on square bars, round aluminium load bars, and most other load bars on the market.
Technical specifications
Model Number - 889800
Warranty
Thule is dedicated to providing exceptional products that are quality tested and guaranteed against defects in materials and workmanship.
An adapter for fitting the Thule ProRide or Thule UpRide bike carriers directly into the t-track (30x24 mm) of some BMW and Renault original load bars.
Technical specifications
Model Number
889101
Units per pallet
1000
Related products
Thule Upride
Thule Proride
Warranty
Thule is dedicated to providing exceptional products that are quality tested and guaranteed against defects in materials and workmanship.
YBX5000 Silver High Performance SMF Batteries
YBX5020 12V 110Ah 900A Yuasa Silver High Performance
Battery Capacity at 20-hour Rate (Ah):
110 Cold Cranking Performance (Amps) EN1: 900
Approximately 50,000 starts Sealed tip/tilt double lid - Reduces water loss by up to 30% - VDA roll over test compliant* Calcium/Calcium plates State of Charge Indicator (SOCI) Integrated carrying handle & flame arrestor OE Quality, Performance & Specification Performance Up to 35% increase in cranking power**
Sigma S32
The Sigma S Series is designed to work independently as a full remote control system linked to the vehicle’s central door locking, or to interface with the manufacturer’s pre-installed remote locking system. All models are manufactured to the highest European certification standards, including Thatcham approval for the appropriate insurance-approved systems.
Utilising the original equipment radio keys, providing perimeter and ultrasonic interior protection
Thatcham Category 2 to 1 upgrade alarm system, providing perimeter and ultrasonic interior protection
Switched from vehicle’s existing OE remote controls
Supplied with self powered siren, and tri-coloured status LED
The system has negative lock/unlock outputs to switch negative controlled CDL systems
Single immobilisation circuit
Key theft protection facility – only with the optional keypad
Auxiliary siren, armed accessory, interior lamp illumination and headlamp illumination outputs
Sophisticated programming and diagnostic facility via the keypad
Security Features
Switches securely from the vehicle’s existing OE remote
Perimeter protection circuit for boot and bonnet (negative input)
Perimeter protection circuit for doors (positive or negative input)
Closed loop protection circuit (looped wire to protect accessories, trailers, bike racks etc)
Ignition detection circuit
Ultrasonic interior protection (base sensitivity adjustable, length of disturbance adjustable, and automatically adjusts if any movement is detected during the threshold time)
Single immobilisation circuit (18 amp continuous/30 amp max)
Manual arm, using the vehicle’s existing OE remote (or programmable auto arm, which automatically arms the system 60 seconds after the last door is shut – adjustable between 1 and 99 seconds. Auto arm can also be programmed to lock the vehicle if required)
Auto re-arm can be programmed to re-arm the system if a door is not opened within 60 seconds of disarming the system -adjustable between 1 and 99 seconds. Auto re-arm also re-locks the vehicle
Key theft protection feature can be turned on to prevent the OE radio keys automatically de-activating the immobilisation when the alarm system is disarmed. In this mode the system’s PIN must also be entered into the keypad before the vehicle can be started. This prevents theft of a vehicle even with the owner’s keys
Last trigger identification via the dashboard LED and a record of the elapsed time since the last trigger, can be recalled using the keypad
The total trigger count memory for each individual circuit since the system was installed or the memory re-set is also stored in the system’s memory
Additional plug in single stage sensor socket (see optional accessories)
Additional plug in dual stage sensor socket and siren pre-warn facility (see optional accessories)
Secure data linked, self powered siren included
Convenience Features
Negative door locking/unlocking control (with the ability to adjust the pulse length, to provide a double pulse or adjust the delay period)
Armed output (negative 200mA max )
Additional siren/pager output (negative 200mA max)
Interior lamp illumination output (negative 200mA max)
Headlamp illumination output (negative 200mA max)
Secure ignition PIN override
Secure PIN override using the keypad
Silent arm and disarm (audible bleeps can be programmed back on, however this will breach current legislation)
The last circuit to trigger can be excluded using the keypad
The vehicle’s battery voltage can be checked using the keypad
The sensors are excludable using the keypad or repeated arming
Personal Safety Features
Auto lock can be programmed to lock the vehicle at the start of a journey when the ignition is turned on, and then unlock when the ignition is turned off. This can be excluded on individual occasions
Optional Accessories
Single Stage Sensors
T-TS1
Tilt sensor. Plug in sensor. Only for use in addition to the ultrasonic interior sensors
AS610
Single stage shock sensor. Plug in sensor. Only for use in addition to the ultrasonic interior sensors
AS620
Single zone microwave. Plug in sensor. Only for use in addition to the ultrasonic interior sensors
Dual Stage Sensors
AS625
Dual zone microwave. Plug in sensor. Only for use in addition to the ultrasonic interior sensors
T2SS
Dual stage shock sensor. Plug in sensor. Only for use in addition to the ultrasonic interior sensors
Other
2012054
RF pager
As a insurance requirement a registered Scorpion installer/Dealer has to do the installation upon purchase details will be sent to a local installer/dealer in your area installation costs depends on vehicle just enquire.
A 51-litre water tank for storing and transporting potable water as well as a wide range of other liquids.
Specs:
- Capacity: 51 Litres
- Specification: Standard camper configuration
- Colour: Black
- Cap: 5" non-vented screw cap
Outlet: 1/2" outlet
Brand
Wydale Plastics
Type
Low Profile Water Tanks
Model
T51FBK5
Height Description
120mm
Width
400mm
Depth
1200mm
Weight
8kg
Colour
Black
Outlet
1/2 BSP
Capacity Description
51 Litres
Country of Origin
United Kingdom
Download
Dimensional Drawing T51FBK5
Patented rack attaches to the front or rear of most bicycles, from full suspension mountain bikes to commuter and road bikes.
Features
Rack remains secure under heavy loads with rubberized grips that prevent sliding and protect bicycle frame
Installation and removal is easy with convenient access to mounting system
Tire clearance up to 29" x 2.5"
Stay visible with the integrated light/reflector mount
Pedal comfortably with adjustable deck and rails that provide maximum heel clearance
Technical specifications
Dimensions
17 x 35.5 x 31 cm
Weight
1.1 kg
Colour
Black
Material
Nylon, steel, aluminum
Model number
100090
Transform your outdoor experience with the OLPRO Pershore Breeze® Campervan Canopy. A blend of functionality, durability and convenience for on the go adventurers.
The Pershore Breeze Campervan Canopy has an adaptable design that will amplify your camping experience. The side pannels can be fully zipped for extra protection against the elements or they can be unzipped and rolled up, or pitched using two canopy poles that are included with your purchase. It's adaptable design makes it suitable for a variety of outdoor activities, ensuring you're prepared for any adventure.
To make the Canopy fully enclosed for those rainy days, our cocoon breeze Universal door is a compatible match (sold separately), allowing you to still enjoy the great outdoors without the worry of getting your furniture or camping accessories wet.
The Pershore Breeze Campervan Canopy features a single beam inflation point, using our Breeze® technology to enhance your pitching experience with a pitch time of just 10 minutes, allowing you to enjoy your adventure hassle free.
Our Pershore Breeze Campervan Canopy is also made from OLTECH® REPRO 150D fabric - repurposed single-use plastic bottles - making it a sustainable alternative to most Campervan Canopies on the market.
The Pershore Breeze Campervan Canopy will connect to your vehicle with the dual beading attached to the tunnel (suitable for awning rails that are 4mm or 6mm) or you can use the awning throw-over straps making the connection between your vehicle and canopy easier than ever.
Suitable for low vans like VW Transporters, Ford Transit Customs or vehicles between the height of 180 and 200 cm
To unlock the full potential of the Pershore, we suggest picking up an extra pair of canopy poles.
Single beam inflation point
Dual Beading on the tunnel (4mm & 6mm)
Tension straps on the tunnel
Tunnel throw-over straps
Cocoon Breeze Door Compatible
Versatile side panels - Can be zipped and rolled up or pitched using canopy poles (two poles supplied as standard, additional poles can be purchased separately)
Low vents
2 Large Windows
2 x Steel canopy poles included.
Carry bag
Manual pump included
180-200cm van height
Suitable for low vans like VW Transporters, Ford Transit Customs etc.
Made from/with:
OLTECH® REPRO 150D Fabric - a sustainable material that is made from repurposed single-use plastic bottles.
OLPRO’s Breeze® technology – reinforced TPU Beams
Specification:
Height: 210cm
Length: 240cm
Width: 350cm
Weight: 6.6kg
Packed Dimensions: 60cm x 30cm x 30cm
Will Fit: All vehicles between the height of: 180cm - 200cm
Colours Available: Grey, Black & Blue
Hydrostatic Head: 5,000mm H/H
Material: OLTECH REPRO 150D
Inflatable Beams: Reinforced TPU Inflatable Beams
Awning Beading: 4mm & 6mm
Sewn-in Groundsheet: No
Pitching Time: Under 10 Minutes
Number of Doors: 1
Number of Windows: 2
Bedroom Inner: No
Standing Room: Yes
What's Included? Manual Pump, Pegs, Guy Ropes, Storm Straps, Tunnel Throw Over Straps, Carry Bag, Repair Kit
This collection was generated by the Seguno app for use in email marketing and is not available on any sales channels. By default, it is configured to show your best-selling products that are in stock and not free.
