The Combi D 6 (E) diesel heater from Truma is a warm air heater with an integrated hot water system (10-litre volume).
Black Cowl VERSION GEN2
In heating and hot water mode, the heater can be used to heat the vehicle and heat water up at the same time. If only hot water is required, the user can select the hot water mode.
Operating modes:
Diesel mode only: for autonomous use
Electric mode only: With 230V for stationary use
Mixed mode (diesel and electrical mode): Only possible in heating and hot water mode
• Heating and Hot Water Mode
In heating and hot water mode, the unit automatically selects the required operating level according to the temperature difference between the temperature set on the control panel and the current room temperature.
If the boiler has been filled, the water is automatically heated as well. The water temperature depends on the selected operating mode and the heater output.
All three energy selection options can be used for winter deployment.
Diesel mode: The unit automatically selects the operating level that is required.
Electrical mode: In this mode an output of 900 W (3.9 A) or 1800 W (7.8 A) can be manually preselected in accordance with the fuse protection at a campsite.
If more output is required (e.g. heating up or low outside temperatures) diesel or mixed mode should be selected so that enough heating power is always available.
Mixed mode: In this setting 230V electrical mode is preferred if the power requirement is low (e.g. for maintaining the room temperature). The diesel burner is not enabled until the power requirement is higher, and is the first to switch off when heating is in progress.
• Hot Water Mode (with filled boiler only)
Diesel mode or 230V electrical mode is used to generate hot water. The water temperature can be set to 40 °C or 60 °C.
Diesel mode: In this setting the water is heated at the lowest burner setting. Once the water temperature has been reached, the burner switches off.
Electric mode: In this mode an output of 900 W (3.9 A) or 1800 W (7.8 A) can be manually selected in accordance with the fuse protection at the campsite.
Mixed mode: This mode is not possible. With this setting the unit automatically selects electrical mode. The diesel burner is not enabled.
Please note: The heater requires DIN EN 590 diesel fuel for operation. Operation using bio-diesel (PME, RME or AME) is not permitted
Product contents:
Combi D 6 E (33516-78)
Combi frost control JG assy (36100-52)
Truma iNet X Panel Bulk Pack (36411-51)
6 Metre control cable (36110-52)
Duct kit Combi D 1.0M BPK12 (34502-73)
Wall Cowl Inner Part (36140-51)
Cowl outer part black ZR80 (36151-59)
4 Metre cable for room sensor (34000-71900)
Fuel line 5x1.5mm BPK 100M (34020-01315)
Caravan Heater Pack FTG 820x1070 (358710)
Caravan Heater Pack Top FTG 580x480x30 (358713)
Caravan Heater Pack Outer 587x487x440 (358707)
Energy sources: Diesel as per EN 590
Rated heat output in gas mode: 2000 W / 4000 W / 6000 W
Rated heat output in electric mode: 900 W / 1800 W
Rated heat output in mixed mode: max. 5800 W
Fuel consumption: 220 - 630 ml/h (110 ml/h with average heat output of 1000 W)
Air flow rate (free blowing) with 4 warm air outlets: max. 287 m³/h
Water capacity: 10 litres
Pump pressure: max. 2.8 bar
System pressure: max. 4.5 bar
Key Features
Diesel heater with integrated heating elements
Digital Truma CP plus iNet ready control panel allows user to easily set required temperature
Powerful fan and even distribution of warm air
Uses little energy
Lightweight and compact allowing for multiple mounting options
Brand
Truma
Type
Air & Water Heaters
Voltage Description
230V AC
Model
Combi D 6 E
Efficiency
Approx. 90%
Height Description
350mm
Width
500mm
Depth
540mm
Weight
18kg
Colour
Black
Flow Rate Description
Air flow: 287 m³/h Max.
Application
Motorhomes
Capacity Description
Water: 10 Litres
Heat Output
6000W
Energy Supply
Diesel as per EN 590
Country of Origin
Germany
Contents
Combi D 6 E, Combi frost control JG assy, Truma iNet X Panel Bulk Pack, 6 Metre control cable, Duct kit Combi D 1.0M BPK12, Wall Cowl Inner Part, Cowl outer part black ZR80, 4 Metre cable for room sensor, Fuel line 5x1.5mm BPK 100M, Caravan Heater Pack FTG 820x1070, Caravan Heater Pack Top FTG 580x480x30, Caravan Heater Pack Outer 587x487x440
Downloads
Operating Manual Combi D 6 (E) Heaters
Operating Manual Truma CP Plus iNet Ready Panel
MPK VisionStar L Pro Rooflight with double glazing impact-resistant polycarbonate dome. Comes complete with a pleated flynet and blind.
Very simple one-hand operation thanks to the bow handle.
VSVPK7503 - Without permanent airflow
Aperture : 700 x 500 mm.
Roof Thickness : 25-60mm.
Dome size : 815 x 583 mm.
Inner frame size : 872 x 610 x 37 mm.
Weight : 7970g
This Adapter Fits Renault Master 2010-Opel Movano 2010-2021 H2 Fits Roof Awnings.
This Adapter Fits Nissan Interstar
Compatible With Omnistor 6300
Awning Length
3.25m Renault Master L2 (5500mm)
3.75m Renault Master L3 (6300mm)
4.00m Renault Master L4 (6700mm)
Adapter Set Of 3 Brackets Of 175mm
Epdm Seal Included
Please Note: This Component Has Replaced DB308959
Please click the Pdf link for More info and installation instructions
The frame of this Scooter Rack is made of steel, which is galvanised to prevent rusting. The ramps, light bar and bracket are made of aluminium. The carrier comes as a complete kit, with ramp, Wheel holder etc.
The foldable scooter carrier is versatile and available for the following applications:
• 1 Scooter Rack
• Scooter and bicycles
• Load capacity 150 kg
The Zorro can be mounted directly on "Al-Ko" chassis or a (reinforced) chassis extension.
Dimensions
Chassis width
Max 1420 mm
Light bar width
1950 mm
Rail width
1950 mm
Depth folded up
approx. 35 cm
Depth folded down
approx. 70 cm
Weight
Payload
150 kg
Own weight
40 kg
Materials
Rails and bracket
Aluminium
Construction
Powder coated steel
Lighting and wiring
Lighting
Aluminium light bar with halogen lamps
Optional
LED lighting
Wiring
13-pin Jaeger socket
Please do not order any of these products without first speaking with our Sales Team. We may need to know more about the vehicle’s specific details to ensure compatibility. In some cases additional brackets will need to be purchased. Incorrect fitting without the correct parts could deem your warranty and any subsequent claim invalid.
Complete form below for product specification for your vehicle!
SOG plug for SOG and SOG II type A (2009 onwards), F and 3000A, as well as for all Thetford cassette toilets type C2, C3, C4 and Porta Potti (2009 onwards), C220, C250, C260, C400, Dometic toilets CT3000, CT4000 and Saneo. Plug suitable for closing the cassette during transport or for emptying. Featuring a practical key ring. 0014.
Brand
SOG
Type
Spare Part
Application
Thetford / Dometic
Exclusively designed adapter for attaching Thule 3200 awnings to aftermarket roof racks.
Durable, heavy-duty steel construction easily attaches to roof racks and the Thule Outland/3200 awning.
Mounts around the load bars up to 90mm wide or into T-tracks
Locking hood protects against theft. Locks included
Fastening tool included.
Please click the PDF link for further information and insulation instructions.
Ducale Mixer.
Classic and timeless design. Suitable for motor homes and caravans. The DIN brass base, chromed metal parts and ceramic valves guarantees a constant and high quality. Suitable for hot water up to 10 bar. Spout rotates 360??. With microswitch.
diameter: max. 50 mm
connection: metal flex hoses
?? 10 mm, 250 mm long
mounting hole: ?? 32 mm
fixing kit
Height 15cm spout: 123mm
Height 22cm spout:180mm
Shurflo Trail King 10 - 12v or 24v Pump
Built-in check valves prevent backflow into the tank. Info: Thermally protected for added safety and peace of mind.
Durable and reliable
Run dry capability
Thermal overload on motor
Flow 10.61/min, 30PSI, 12V or 24V
Durable and reliable high pressure pump - ideal for pressure systems in caravans, motorhomes and boats
Built-in check valves prevent backflow into the tank
Thermally protected for added safety and peace of mind
Thermal overload on motor. Run dry capability
30psi. 10.6 Ltr /Min
12V 70dB
24V 71DB
Light and easy to use bike rack for the A-frame.
Features:
Designed for the installation on the A-Frame Foam bumpers prevent the bike from being damaged during transport Partly tiltable - bikes need to be taken off to access storage space
Technical specifications:
Compatibility Caravans Mounting location Caravan A-Frame Load capacity for bikes2Max bike weight20 kg Max weight capacity40 kg For e-bikes - Sliding rail in depth - Sliding rail left-right - Lockable bike-to-rack - Total width 126 cm Height 68 cm Depth 32 cm Weight 4.7 kg
